Omnitron-systems-technology FlexSwitch 6530 FK Bedienungsanleitung

FlexSwitchTM 4FxModel 6530-FKReplacement KitUser Manual 140 Technology #500, Irvine, CA 92618 Phone: (949) 250-6510; Fax: (949) 250-6514

WarningThe operating description in this Instruction Manual is for use by qualifiedpersonnel only. To avoid electrical shock, do not perform any servi

TECHNICAL SUPPORTIf you encounter problems with this product, contact Omnitron TechnicalSupport.Phone: 800-675-8410949-250-6510Fax: 949-250-6514Addres

Table of Contents1.0 INTRODUCTION ... 31.1 General Description ...

1.0 INTRODUCTION1.1 General DescriptionThe 6530-FK is the direct replacement for the discontinued FlexSwitch Model600XC 4Fx. The 6530-FK replacement

2.0 INSTALLATION2.1 Chassis InstallationThe 6530-FK is designed to accommodate wall-mounting and tabletopinstallations. For wall-mounting, the 8249-0

3.0 CONFIGURATION3.1 AC Site Preparation• Power source should be available within 5 ft. of the chassis and installedper the National Electrical Code A

3.3 Configuring the DIP-Switches3.3.1 Media Converter Modules - Front PanelThe Media Converter Modules have been pre-configured for full duplexoperati

the LEFT position, Link Propagate mode is enabled.Note: Setting both the “LP”, “ RFD” and “SFD” to the RIGHT positions onthe same module is an illegal

5.0 SPECIFICATIONSDescription Four Port Fast Ethernet Optical SwitchProtocols 100Base-FxFiber Cable Type Multimode: 50/125, 62.5/125,100/140umSinglem

6.0 LINK MODESIn order to accommodate different user requirements, the 6530-FK MediaConverter Modules support five different link modes:Link Segment (