Omnitron-systems-technology FlexSwitch 6540 FK Bedienungsanleitung

FlexSwitchTM 2Fx+2UModel 6540-FKReplacement KitUser Manual 140 Technology #500, Irvine, CA 92618 Phone: (949) 250-6510; Fax: (949) 250-6514

6.0 LINK MODESIn order to accommodate different user requirements, the 6540-FK MediaConverter Modules support three different link modes:Link Segment

WarningThe operating description in this Instruction Manual is for use by qualifiedpersonnel only. To avoid electrical shock, do not perform any servi

TECHNICAL SUPPORTIf you encounter problems with this product, contact Omnitron TechnicalSupport.Phone: 800-675-8410949-250-6510Fax: 949-250-6514Addres

Table of Contents1.0 INTRODUCTION ... 31.1 General Description ...

1.0 INTRODUCTION1.1 General DescriptionThe 6540-FK is the direct replacement for the discontinued FlexSwitch Model600XC 2Fx + 2U. The 6540-FK replace

2.0 INSTALLATION2.1 Chassis InstallationThe 6540-FK is designed to accommodate wall-mounting and tabletopinstallations. For wall-mounting, the 8249-0

3.0 CONFIGURATION3.1 AC Site Preparation• Power source should be available within 5 ft. of the chassis and installedper the National Electrical Code A

3.3 Configuring the DIP-SwitchesThe 6540-FK has been pre-configured with Auto-Negotiation enabled on allUTP ports for plug and play easy of use. Howe

Note: Attaching the Auto-Negotiating UTP port of the 6540-FK to a devicewith a manual/forced /hard-coded UTP port may result in an unpredictableport s

4.0 LED INDICATORS4.1 Media Converter ModulesThe Media Converter Modules have LED indicators to provide informationon how the module is communicating

5.0 SPECIFICATIONSDescription Fast Ethernet Switchwith two 10/100 UTP Ports and two 100 Fiber PortProtocols 10Base-T, 100Base-Tx, 100Base-Fx with 1522